Remote Tuning - Black Box AC3000A-R2 Series Manual

Chapter 7: HD View System Management
5. Once you have a satisfactory image, press "Store" to keep the
present tuning configuration.
6. Click "Save Preset" to save the tuning configuration for future
use. The Enter Name box appears.
7. Type a name for the preset and click "OK." The tuning
configuration now appears in the drop-down menu.
Delete preset—to delete a tuning configuration from the
drop-down menu, click "Delete preset."
Restore—If after changing values you change your mind, you
can restore the values to how they were the last time the Store
button was pressed by pressing "Restore."

7.6 Remote Tuning

You can tune the Receiver and Line Splitters from any laptop or
other mobile device via a Web browser. Through the browser
you access the player running the Service utility via the local
network. This enables you to tune the screen when standing in
front of it without the need to be physically connected to the
Receiver/Line Splitter. The Service Utility must be installed on the
players but is not needed on the remote tuning device.
At the player, the setup is done as follows:
1. Connect the Serial Download cable to the Transmitter and
player.
2. Open the Service Utility and choose "Tools/Options," and the
Preferences window appears, see Figure 7-3.
3. Select the "Enable Remote Control" checkbox, and the
software starts a small web server in the background allowing
other computers on the network to access it. The "Check
Remote Control" button un-grays. Click the button to display
a local browser to indicate that the remote option is enabled
and functioning.
4. To verify the IP address of the player, click "Start/Run," type
"CMD" press "Enter", type "IPConfig" press "Enter." The IP
address appears.
Page 42
724-746-5500 | blackbox.com