Digital Controller - Frymaster CF Series Operating Instructions Manual

DIGITAL CONTROLLER

This controller uses a temperature probe and
solid-state electronics. Pressing the ON/OFF
switch supplies electrical power to the
fryer, and causes the controller software ver-
sion number to display for 4 seconds in the
Digital Display.
Following the software version number dis-
play, the SETPOINT TEMPERATURE
WILL DISPLAY CONSTANTLY. Pressing
the Temperature/Setpoint Display switch will
display the actual frypot temperature.
The fryer will automatically enter the melt
cycle mode and will continue to cycle on for a
few seconds and off for a longer period until
the temperature in the frypot reaches 180ºF
(82ºC). At that time, it will enter the heat
mode. The purpose of the melt cycle is to
gradually melt solid shortening to prevent
CF SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
ON/OFF Digital
Switch Display
9 . 9
Frymaster
Temperature Setpoint
or Setpoint Adjustment
Display Switch Arrows
DIGITAL CONTROLLER
3-10
Celcius or
Fahrenheit
Display Switch
9 9
Melt
Cycle
Switch
scorching, and to prevent creation of "hot
spots" on the frypot. To cancel the melt cycle,
press the Melt Cycle switch
The fryer will remain in the heat mode until
the setpoint is reached. The Heat Mode Indi-
cator is a decimal point that appears between
the first two numbers of the digital display to
indicate the unit is heating. When the setpoint
is reached, the decimal will go out; indicating
the fryer is ready for cooking.
To enter or change the setpoint, press an arrow
key to raise or lower the temperature setting.
The display will change at a rate of about 1-
degree per second for approximately the first
12 degrees, then change to a faster rate if an
arrow is continuously pressed.
The temperature can be displayed in either
Fahrenheit or Celsius. To change from one to
the other, press the C/F switch
Heating
Mode
Indicator
.
.