Del ozone Spa Solar Eclipse Installation Manual page 7

after 18 months of use, even if the Blue UV Lamp Indicator is still
lit.
i. Make sure the unit is disconnected from power and the lamp
has cooled before starting maintenance.
ii. Open the Spa Solar Eclipse by removing the screw on the
bottom of the Upper Enclosure Assembly, rotating it up and
pushing it back to release it from the Assembly Pin.
iii. Unplug the Lamp Connector Plug attached to the top of the
UV Lamp and place the Upper Enclosure Assembly in a safe
place.
iv. Slowly pull the UV Lamp out of the Quartz Tube by the
white ceramic prong end. dO NOT TOUCH THE UV lAMP
GlASS wITH YOUR bARE HANdS. The oils on your
hands can cause hot spots on the lamp and shorten its life. If
oil from your fingers is left on the lamp glass, clean it off with
a soft towel and rubbing alcohol. If you are removing an old
lamp for replacement, handle the lamp carefully and dispose
properly (see Environmental Notice below).
v. Make sure the two o-rings and the end cushion remain on
the ceramic ends of the lamp as it is set aside in a safe
place.
b. Installing the UV lamp
i. Make sure to handle the new lamp as described in Section
6a and clean the UV Lamp before installation if needed.
ii. Slowly place the UV Lamp into the Quartz Tube until it
contacts the bottom of the tube.
iii. Connect the Lamp Connector Plug to the pins on the lamp.
NOTE: Do not force the Lamp Connector Plug onto the pins. If force
is needed, it means that the components are misaligned.
ENVIRONMENTAl NOTICE: UV Lamp CONTAINS MERCURY.
Manage in accordance with disposal laws.
See: www.lamprecycle.org
c. UV Reactor Service and Maintenance
The UV Lamp is housed in a Quartz Tube. If the Quartz Tube
becomes dirty, its ability to transmit rays from the UV Lamp will
be diminished and decrease system performance. The Quartz
Tube should be removed from the UV Reactor at least once a
year, or during a routine spa water change for inspection and
cleaning if necessary.
SES Installation & Operations Manual
4