Table of Contents
Advertisement
5. Maintenance and service instructions
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the ma-
chine and ventilation slots clean.
5.1 Cleaning
Clean the saw blade holder preferably with compressed air or a
soft brush. Remove the saw blade from the power tool for this.
Ensure proper operation of the saw blade holder by applying a
suitable lubricant.
Heavy contamination of the machine can lead to malfunctions.
Therefore, do not saw materials that produce a lot of dust from
below or overhead.
5.2 Repair service
Our after-sales service responds to your questions conceming
maintenance and repair ofyour product as well as spare parts.
Exploded views and information on spare parts can also be
found under: info@grupostayer.com
Our customer consultants answer your questions conceming
best buy, application and adjustment of productsand accessories.
5.3 Warranty
Warranty card
lncluded in the documentation that accompanies this equipment,
you should find the warranty card. You should fill out the card
completely and retum to vendar with a copy of purchasing
receipt or invoice and you should receive a receipt.
Note: lf you cannot find the warranty card within the
documentation,youmust ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or repaired
otherthan themanufacturer.
5.4 Disposal and recycling
The machine, accessories and packaging should be sorted for
environmental-friendly recycling.
OnlyforEC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC for
Waste Electrical and Electronic Equipment and its
implementation into national right,power tools that
are no longer usable must be collected separately
and disposed of in an environmentally correct
manner.
Subject to change wlthout notlce.
ENGLISH
8
6.Regulations
6.1 Technical Data
= Voltage
=Rated power input
= Battery power
= Load speed
= Battery charging time
= Displacement of the Sierra
= Length of the blade
= Wood cutting capacity
= Capacity Metal Cutting
= Cut Aluminum Capacity
= Weight
L
=Sound power level
WA
L
=Sound pressurelevel
PA
=Vibration
The values givenarevalid for nominalvoltages [U]230/240
V-50/60 Hz - 110/120 V- 60Hz. For lower voltage and models
for specific countries, these values can vary.Please observe
the article number on the type plata of your machine.The
tradenamesoftheindividualmachines may vary.
NoiseNibration lnformation
Measuredsoundvalues determined according to EN 60745.
Typically the A-weighted noise levels of the product are: See
technical data table (page 5).
Wear hearing protection!
Vibration total values ah (triax vector sum) and uncertainty K
determined according to EN 60745:
Cutting board: a
=14m/s
h
Cutting wooden beam: a
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with another. lt
may be used for a preliminaryassessment of exposure.
8
, K=1.5 m/s
,
2
2
=19.5m/s
, K=1.5m/s
.
2
2
h
Advertisement
Table of Contents
