Connection Panel - Montarbo FIRE PASSIVE MK2 Series Owner's Manual

Connection panel

[1]
[1] Input speakON connector [INPUT]. Connect it to the power amplifier
®
or to the powered mixer output.
Active terminals are [1+] and [1–].
Terminals [2+] and [2–] are not used.
Warning! Never connect two amplifiers to the same loudspeaker.
speakON ® is a trademark under property of Neutrik ® AG, registered in US and other Countries.
[2] Input link speakON connector [LINK]. Wired in parallel to the input
®
connector, making it possible to drive another, parallel connected,
speaker system. Always pay attention to the total impedance.
[!] NOTE:
Use only loudspeaker cables (unscreened) having
suitable cross section (at least 2 x 1.5 mm
twist or sharply bend the cables and do not allow for knots to be
formed, because they may result in insulation damage.Do not use
shielded cables (microphone/signal cables).
Series FIRE PASSIVE MK2 | Owner's manual |
[2]
) and quality. Do not
2
23