Update Firmware; Option 1: Update Through Philips Soundstudio (Recommended); Option 2: Update Through A Usb Mass Storage Device Or Pc/Mac - Philips DS9800WS User Manual

7 Update
firmware
Warning
•
Always connect your DS9800WS to AC power for
firmware upgrade. Never power off your DS9800WS
during firmware upgrade.
You can update the firmware either
through a USB mass storage device
(recommended) or from a PC/Mac.
Option 1: Update through
Philips SoundStudio
(recommended)
1
Run the Philips SoundStudio app on your
iPod/iPhone/iPad.
2
Go to the Settings tab of the app.
3
Select Firmware upgrade.
4
Follow the on-screen instructions to
check for new firmware and proceed with
upgrade.
Option 2: Update through a
USB mass storage device or
PC/Mac
Download the update file
www.philips.com/support
1
On your PC/Mac, go to www.philips.com/
support.
2
Enter the model number to find the latest
firmware upgrade file available.
3
Unzip and save the upgrade file to your
hard drive.
Update through a USB mass storage device
Note
•
Make sure that the USB mass storage device is
FAT16/32 formatted.
1
Power on DS9800WS (see 'Turn
DS9800WS on' on page 9).
» It takes about 35 seconds for the unit
to boot up. During boot-up, the WI-FI
STATUS indicator on the back of the
main speaker blinks yellow.
» After boot-up, you can hear a beep
and the WI-FI STATUS indicator turns
solid green.
» DS9800WS is connected to the last
configured Wi-Fi network automatically.
XXXX
XXXX. zip
EN 23