Control Rods - Kangke TEXAS HURRICANE Assembly Manual

Repeat the procedure with the wing servos. Pre
drill the servo screw holes and open the control
horn slot.
Use the pull string to work the servo extension
through the wing and out the exit hole in the root
rib.
Install the wing servos with the provided screws.

CONTROL RODS

Using a control horn back plate, line up the edge
with the top of the elevator bevel 5/8-inch out from
the inside corner of the elevator. Drill a hole at this
location.
Install the elevator control horn using a screw,
backing plate and a control link. The elevators get
the mid size horns.
Be sure the servo is centered and the elevator
neutral. Measure and fabricate a control rod. For
sport flying 2-56 rods will work, but for the loads
required for advanced aerobatics 4-40 rods are
recommended.
10