Kangke TEXAS HURRICANE Assembly Manual page 12

wing servo wires.
Fabricate and install the throttle control rod. Be
sure the throttle will open and close all the way
without binding the servo.
Install the fuel tank. Use the supplied wood
supports, leave enough room to surround the tank
with foam rubber.
CANOPY
Trim the canopy carefully along the scribed lines.
Sand the edge smooth; be careful not to scratch the
surface.
Detail the pilot compartment to the level desired.
Locate the canopy for best fit; tape securely. Drill
two 1/8-inch holes in each side of the canopy only
then secure with the supplied screws. Remove the
screws and harden the threads with CA. An
alternative method, if you don't want the canopy
removable, it may be glued on using canopy
adhesive. Additional trim may be added as desired.
If you engine requires ignition and battery now is
the time to install them. Install the engine cut-off
switch as directed by the engine manufacture.
Install fuel lines and all other engine accessories.
Carefully add any openings the cowl may require
for cooling and adjustments. Mount the cowl using
the supplied screws.
12