Table of Contents
Advertisement
other side, apply epoxy and center the stabilizer
using the outline of the fuselage as a guide. Verify
the alignment using the string as before, correct if
necessary. Wipe off excess epoxy with a paper
towel moistened with alcohol and allow curing.
After the epoxy has cured apply a few drops of thin
CA type adhesive in the fin slot on the top of the
fuselage and allow to cure.
FIN ASSEMBLY
Trial fit the fin in the fuselage. Use a pin stuck in
the center of the top and a string to verify its
alignment. Use a felt tip marker and mark the
outline of the fuselage on the fin.
Using the same procedure as was used with the
stabilizer, remove the covering where the wood will
be glued.
Apply epoxy to both sides of the fuselage slot as
well as both sides of the fin. Slide the fin in place
using the fuselage outline as a guide. Wipe off the
excess epoxy with a paper towel moistened with
alcohol. Verify the alignment with the string and
allow to cure.
SERVO TRAY / CONTROL RODS
Temporarily install the motor mount with 4 M-4
screws provided.
Temporarily install the motor centering it in the
mount.
The throttle push rod must travel in a straight line
from the throttle horn on the carburetor to the
firewall. Using a pencil as shown make a mark on
the firewall 1/4 inch outside the mount.
Trial fit your servos in the servo-mounting tray,
open the holes if necessary, do not mount the servos
at this time. Trial fit the servo-mounting tray in the
fuselage, be sure the throttle servo hole is on the
same side as the carburetor. The tray should fit
snugly between the fuselage sides and against the
center bulkhead. Epoxy in place when satisfied with
the fit.
5
Advertisement
Table of Contents
