Motor Instalation; Landing Gear - Kangke TEXAS HURRICANE Assembly Manual

Install the upper flying wires. Once again only
make them tight enough to eliminate all endplay.
No knurl nuts are used on the top wires.

MOTOR INSTALATION

The following instructions show the installation of
the BRISON AIRCRAFT 2.4 engine.
{www.brisonaircraft.com 972 241 9152}
Because of the 1 ½-degrees of right thrust built into
the engine support follow the instructions to be
sure the spinner lines up correctly with the cowl.
Locate the crankshaft horizontal centerline by
measuring 2 ¼ inches up from the bottom of the
engine support. Locate the vertical centerline 1/4-
inches to the LEFT of the engine support center.
The back of the spinner should be no less than 5
5/8-inches from the engine support. The BRISON
2.4 used in the prototype required a ¾-inch spacer
made from hard wood.

LANDING GEAR

Slide the axle through the deep offset in the wheel,
Install the wheel spacer followed by the regular
nut.
The main gear has a front and back, when installed
correctly the gear will have a forward sweep. Using
the supplied screws install the gear on the fuselage.
Using the small screw, two flat washers and a
6