Control Throws - Kangke HOWARD DGA 15 Assembly Manual

The large wing numbers fit on the top of the
RIGHT wing. I found it easy to apply the
numbers by laying down a guide line of masking
tape and the lining up and marking the tape and
numbers lightly with a pencil before applying.
Once in place, remove your guide tape and
remove the pencil marks. The marks should
come off with a bit of water and paper towel.
Assemble the model, affixing wings and struts,
making any adjustments necessary. You may
find that it will be necessary to do a little bit of
fine trimming for the windscreen.
Recheck the balance & RECHECK
AGAIN.
The balance point is 27% of wing cord
or 4.05 inches back from the leading
edge.

CONTROL THROWS

With your radio on, center all trims and adjust
the clevises so all control surfaces are straight.
Measure the control surface movement at the
widest part of each surface. Use the servo horns
and bell crank holes to adjust the control throw.
For your first flights the control throws should be
set to the following:
Elevator 1." up/down (low)
2." Up/down (high)
Rudder 2 " right/left (low)
1" right/left (high)
Aileron 3/4" up/down (low)
1 1/2" up/down (high)
It is important to double check that all
controls move in the proper direction.
14