Advertisement
LCD DISPLAY FEATURES
The image shows the various features and information displayed on the wireless remote. The display
is controlled using the 3-button remote mounted on the left side of the handlebar. For more
information on the LCD display and operation please refer to the manual included. This is also on
located on our website at
www.wattwheels.co.nz/manuals
LIGHTS
To activate the lights press down the up key on the keypad for three seconds. The display should
light up and a little icon appear above the PAS level indicator. This will also activate the rear light. To
turn off press the up key down for a further three seconds. The rear light when not turned on is
activated by pressing the brakes levers and will light up each time you press the brakes. This
indicates to the person behind you that you are braking.
BATTERY DISPLAY CAPCITY
The LCD readout on the handlebar of your Scout Bike features a battery capacity gauge (much like
the fuel gauge on an automobile). Once the battery is fully depleted, the last remaining bar will
begin to flash, communicating to the user that they should cease operation immediately.
THROTTLE
The Throttle is located on the left-hand side of the handlebars in the form of a thumb piece. Please
be careful that these throttles are set to operate the Scout from stationary so any slight press of this
will propel the Scout forward. The throttle can be used when taking off from a stationary start, as a
cruise control or just if you're in need of a break! Please be aware using the throttle will drain the
battery much quicker than normal riding. Also, the throttle is not designed to climb steep hills. To
get the maximum amount of power from the Scout on steep gradients select the highest level of PAS
and use the highest gear.
Advertisement
