Installation; Maintenance; Accessories - IKA Lab disc Manual

Starting up
- Connect the appliance to a socket (the voltage stated
on the nameplate must correspond to the mains volta-
ge).
- Number of revolutions to minimum value set
(switch on with
of revolutions to LED 2 permanently shines)
- Place a magnetic rod in a vessel which is penetrable
for magnetic field lines and fill the vessel with the
medium to be processed.
- Place the vessel on the centre of the set-up surface.
- Set the speed using
To elect the reverse mode and invert the direction of stirring
at regular intervals, press the button
the stirring direction will be inverted every 30 seconds; there
will be pause of 5 seconds between each changeover. The
LED 1 will flash when the revers mode is active.
The speed setting and revers mode selection will remain
unchanged when the instrument is unplugged.
Caution: At some speeds, irregularities in the shape of
the stirring bar and of the bottom of the container can cause
the bar to move irregularly during stirring. Increase or decre-
ase the speed until the stirring bar begins to rotate evenly.
10
, with reduce number
and (LED 2 will flash)
. In the revers mode

Maintenance

The appliance is maintenance-free.
Cleaning
Only use cleansing agents which have been recommended
by IKA.
Use to remove:
Dyes
construction materials water containing tenside,
Cosmetics
Foodstuffs
Fuels
- Do not allow moisture to get into the appliance when
cleaning.
- Wear protective gloves during cleaning the devices.
- Before using another than the recommended method for
cleaning or decontamination, the user must as certain
with IKA that this method does not destroy the instru-
ment.

Accessories

IKA - stirring bars:
TRIKA ® 25
IKAFLON
Stirring bar remover
Isopropyl alcohol
isopropyl alcohol
water containing tenside,
isopropyl alcohol
water containing tenside
water containing tenside
® 30