Advertisement
Figure 1
For fuce ratings
see text
Figure 4
1. To instal the device you have to dismantle carefully the device with a flat screwdriver as
shown in figure 1.
2. Pass the mains cables through the hole (point 1 in figure 2). The luminaire must be
connected to a permanent electrical installation to ensure the immobilization of the cable.
3. Mount the base plastic on the wall by using the included mounting accessories in points 2
and 3 in figure 2.
4. Connect the battery`s cable with the appropriate terminal (figure 3).
5. Connect the mains cables to the terminal block as shown in figure 4.
6. Refit with care the removed plastic parts and power on the luminaire.
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the nominal autonomy.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained (*)
A: Including test device
G: Internally illuminated
180: 3 hours duration
Battery replacement.
It can be done only by a competent person and after the mains supply interruption.
1. Dismantle the device (step 1 of the installation instructions).
2. Disconnect the connector and remove the old battery.
3. Connect the new battery with the same type (step 4 of the installation instructions) and
place it in the position of the old one.
4. Follow the step 6 of the installation procedure and power the device.
Page 2 from 3
Installation instructions
1
3
Connection terminal
block on the PCB
Figure 2
Non-maintained
(*) Maintained operation: The luminaire lights its
illumination source, when it is powered by the mains
power supply or not.
Non Maintained operation: The luminaire lights its
illumination source, only in power supply's failure.
Note!! The installer should fill in, on the specification label,
the letter G if the luminaire is used as a safety sign.
X 1
A G
1 8 0
Figure 3
2
Maintained
operation
oparation
923211002_09_004
4
Advertisement
