Advertisement
S Assemble the connecting link to the rod with the
clip.
S Insert the lift rod through the faucet escutcheon
from the underside, and thread the lift rod knob
to the lift rod.
S Slide the faucet lift rod through the hole in the
link.
S Wrench tighten the screw on the link so the lift
rod knob is 1/2" above the lift rod hole.
IF THE LAVATORY IS NOT INSTALLED, INSTALL IT AT THIS TIME. BE SURE TO
FOLLOW ALL INSTRUCTIONS PACKED WITH THE LAVATORY.
SUPPLIES AND STOPS
S Connect the supply tubes to the faucet inlets and
supply stops (Left is hot – right is cold.)
S Wrench tighten all connections.
INSTALLATION CHECKOUT
S Connect the tailpiece and P-trap.
S Ensure that all connections are tight.
S Remove the aerator.
S Open the drain.
S Turn on the main water supply and check for
leaks.
S Open the valve and run water through the spout
to remove any debris. Turn the valve off.
S Reinstall the aerator.
CALL US FOR HELP – 1-800-4-KOHLER
REQUESTING SERVICE
Here's what you need to do if you require service:
First review the installation instructions to ensure correct installation. If you are still unable to correct
the problem, call our Customer Service Department for direct help. Dial 1-800-4-KOHLER.
BA
116585-2-
(-)
Thumb Screw
Clip
Rod
Supply Tube
4
Link
Supply Tube
Spout
Aerator
Kohler Co., Kohler WI
Advertisement
