1. Secure the handle cover to the internal RDX docking station (FC EUA3) by sliding it toward the rear
of the system. See Figure 121.
Figure 121. Securing the handle cover in an 8286-41A stand-alone system
2. Insert the piece within the handle cover by pushing it firmly into the handle cover as shown in
Figure 122.
Figure 122. Inserting the piece within the handle cover on an 8286-41A stand-alone system
3. Place the side cover down over the 8286-41A system.
4. Slide the side cover into place until secured onto the system as shown in the following figure.
Note: Ensure that the side cover tabs are aligned properly.
138
System backplane