Standby Mode - Texas Instruments 900 Series User Manual

Power Saving Modes
In 5V Suspend mode, the computer saves the
current computer state onto your system
memory then shuts off power to most of the
devices except the system memory. The standby
indicator flashes to indicate the computer is in
5V Suspend mode. When the computer resumes
from 5V Suspend mode, it restores the computer
to the saved state.
Press the 5V Suspend hot key (Fn+F3) or close
the display cover to enter 5V Suspend mode.
The computer also enters 5V Suspend mode if
the
enabled and times out.
To resume normal operation, press any key on
the internal keyboard or press the power switch.
The computer also resumes from 5V Suspend if
the
options are enabled in the System Setup and a
modem ring or alarm occurs.
Note: It takes the computer a few seconds to
resume from a 5V Suspend. You may see the
screen blank a few times while the computer
restores all of the system states.

Standby Mode

Standby mode saves some computer power by
turning off a few of the unused devices and still
allows you to resume your work instantly. The
standby indicator lights up in Standby mode.
1-12
5V SUSPEND TIMEOUT
RESUME ON MODEM RING
parameter in Setup is
or
RESUME ON ALARM