Nice BIO Series Manual page 29

- Keep the button on the receiver pressed (approx. 3 sec.) and then the LED will switch off, then
release the key.
- Press any button on the new transmitter to send the code three times until the LED switches
!
off again.
Release the transmitter key and wait 1 sec.
- Press any key on the transmitter to send the code for confirmation.
The LED will flash once to indicate that the code has been deleted. If this does not occur, repeat the entire
operation from scratch.
DELETING ALLCODES
This operation lets you remove all codes stored in memory (which is reset empty). The 2nd learning lock is
also removed and the TIMER is reset to default time of 3 sec. (only for special version).
The operations are timed and you thus need to read all the instructions to perform the operation in sequence
without stopping.
- Keep the button on the receiver pressed and after 3 sec. the LED will switch off;
- Release the key duringthe 3rd following flash.
!
- Wait about 3 sec.
- Press the key as soonas the LED lights up again and release it as soonas it switches off.
After a few seconds 5 flashes will follow to indicate that the memory has been reset and is empty. If this does
not occur, repeat the entire operation from scratch.
-29 -
GB