Nice BIO Series Manual page 27

PUSH BUTTON
Fig. 6
ENTERING A CODE
This operation lets you add the code of a new transmitter into the receiver's memory.
The operations are timed and you thus need to read all the instructions to perform the operation in sequence
without stopping.
- Press the key on the receiver for a moment to switch on the LED for 5 sec.In this time you have to:
- Send a code until the LED is switched off by pressing any button on the transmitter.
!
- Release the transmitter key and wait 1 sec.
- Press any button on the transmitter to send the code for confirmation.
The LED will flash three times to indicate that the operation has been successfully completed. If this does not
occur, repeat the entire operation from scratch. To enter a new code, repeat the whole operation.
LED
MEMORY CARDS
- 2 7 -
GB