Nice BIO Series Manual page 28

REMOTE CODE INPUT
To insert the code of a new remote control without pressing the receiver key, you need to have the previously
authorized remote control(consequently the first remote control code is always entered by pressing the recei-
ver key). All the instructions should be read to perform the operations in sequence without stopping. Now with
the remote control whose code is to be entered called NEW and the previously authorized one called OLD,
stand within the radio control's operating range and then:
- Press any button on the NEW transmitter to send the NEW code for at least 5 sec.
Now slowly but positively;
!
- Press any button on the OLD transmitter three times to send the OLD code three times;
- Press any button on the NEW transmitter to send the NEW code once for confirmation.
The operation has now been completed and can be repeated immediately with a new remote control.
NB: This operation enters the new code in all receivers locating within the operating range that reco-
gnize the old code (and which are not disabled). Therefore, if there are several receivers nearby with
the old code previously entered, switch off those not involved in the operation.
DELETING A CODE
This operation lets you remove a code from the receiver's memory.
The operations are timed and you thus need to read all the instructions to perform the operation in sequence
without stopping.
- 28-