3M Versaflo M-973 User Manual page 47

Radiant heat cover

Table of Contents

Available languages

• The radiant heat cover may not eliminate all risks of burns if worn directly next to the skin.

• The cover should be used as part of a complete range of protective garments that are selected in accordance with the employers risk assessment. The

cover is designed for use in combination with the 3M™ Versaflo™ M-Series Over-visor.

• Materials which may come into contact with the wearer's skin are not known to cause allergic reactions to the majority of individuals.

APPROVALS

These products meet the requirements of the European Community Directive 89/686/EEC (Personal Protective Equipment Directive) and are thus CE

marked. Certification under Article 10, EC Type-Examination and Article 11, EC Quality Control, has been issued by Certification Ltd., Unit 14 Wheel Forge

Way, Trafford Park, Manchester, M17 1EH, UK (Notified Body number 0338).

MARKING

The radiant heat cover is marked in accordance with EN ISO 11612:2015.

Protective clothing against heat and flame.

A1, B1, C4, D3, E3 - See technical specification for details.

PREPARATION FOR USE

^ Inspect the product carefully before each use. Replace any parts that show signs of damage such as wear, abrasions, tearing or loss of aluminium

coating. Do not attempt to repair the product if damaged.

^ In order to ensure that the product provides the expected level of protection it is essential that it is assembled correctly and in accordance with the

instructions provided.

Assembly

1. Remove the face seal from the helmet (see M-Series instructions).

2. With the visor in the up position, pull down on metal spring and pull out to remove (See Figure 1).

3. Remove the visor frame (See Figure 2).

4 Remove post with red "3M" from visor frame by placing the frame on the edge of a table, resting on the post, and press down forcefully on the visor

frame with heel of hand (See Figure 3).

5 Remove the visor gasket from the upper edge of the visor (See Figure 4).

6. Pass the attachment of the over-visor Carrier (M-961) through the holes provided in the fabric cover. Ensure that the square part is fully exposed on

the opposite side of the fabric (See Figure 5).

7. Attach the over-visor carrier (M-961) to the frame ensuring that the carrier locks into place (See Figure 6).

8. Raise the over-visor carrier to the upright position and insert the visor gasket into the visor (See Figure 7).

9. Insert the helmet into the fabric cover to attach the visor back on to the helmet. Ensure that the breathing tube connector is exposed in the hole

provided and that the fabric is not trapped between the visor and the helmet (See figure 8).

10. Line up the visor frame over the attachment slots and slide the metal spring into place (Fig 9). Note: The visor frame should be in the fully open or

closed position before the spring is installed.

11. Attach the self-adhesive hook and loop fastener to the helmet as shown (See Figure 10).

12. Attach the over-visor to the over-visor Carrier and lock into place (See Figure 11). Ensure the visor selected is correct for the application and fitted

the right way round.

CLEANING INSTRUCTIONS

Wipe clean only to prevent degradation of the protective performance of the radiant heat cover.

STORAGE AND TRANSPORTATION

Do not store the product in direct sunlight or at high temperatures.

When not in use, it should be stored in a cool, dark location to prevent the material from ageing.

When stored as stated, the expected shelf life of the product is 1 year from date of manufacture.

The original packaging is suitable for transporting the product.

Dispose of the product in accordance with local regulations.

TECHNICAL SPECIFICATION

Fabric Performance

EN ISO 11612 Code letter and classification