System Description; Warnings And Limitations - 3M Versaflo M-973 User Manual

7. (M-961)
8.
9.
10.
11. ,
12. ,
,
,
,
EN ISO 11612
A1
B1
C4
D3
E3
M-307 = M-973
M-407 = M-975
An
Please read this User Instruction in conjunction with the 3M™ Versaflo™ M-Series and 3M™ Versaflo™ Over-Visor User Instructions as required.
^ Particular attention should be given to warning statements where indicated.

SYSTEM DESCRIPTION

The 3M™ Versaflo™ Radiant Heat Cover is designed to be used in conjunction with the 3M™ Versaflo™ M-Series Headtops to provide additional
protection against heat and flame.
This product meets the requirements of EN ISO 11612:2015 (Protective Clothing – Clothing to protect against heat and flame).
Note: Use of certain accessories to provide protection, in addition to the respiratory protection afforded by the headtop, may mean the mass requirements
(Clause 6.16) of EN12941 are exceeded. Please contact 3M for further information.

^ WARNINGS AND LIMITATIONS

• Proper selection, training, use and appropriate maintenance are essential in order for the product to help protect the wearer from certain
physical hazards.
• Failure to follow all instructions on the use of these personal protection products and/or failure to properly wear the complete product
during all periods of exposure may adversely affect the wearer's health, lead to severe or life threatening illness or permanent disability.
• For suitability and proper use follow local regulations, refer to all information supplied or contact an occupational hygienist, safety
professional or 3M representative on the Tech Assist Helpline 3M Australia 1800 024 464, 3M New Zealand 0800 364 357.
• See all instructions for use and save for continuing reference.
• Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
• Check apparatus is complete, undamaged and correctly assembled. Any damaged or defective parts must be replaced with original 3M spare parts
before use.
• In the event of a molten metal, chemical or flammable liquid splash:
- The user must leave the work place immediately and remove the product carefully avoiding contact with the hazardous material.
- The product should then be inspected and cleaned or removed from service.
• The Radiant Heat Cover is designed to provide additional protection against heat and flame to the helmet, head, neck and shoulders.
,
,
,
(8-
,
.
(11- ).
,
, ,
.
45
(6- ).
(7- ).
.
).
(9- ). :
(10- ).
.
.
.
1 .
.
,
.