Wiring Of Equipment; Connection With Pc (Bluetooth Pairing) - YOKOGAWA IB100 Instruction Manual

10

2.4 Wiring of equipment

Please use the correct type (see Note) WU11 to connect IB100 and SENCOM sensor/
SA11 SENCOM Smart Adapter. Please tighten nuts securely after connection. To prevent
misconnection, the connector and counterpart both have positioning notch. After IB100 and
SENCOM sensor are properly connected, status LED starts lighting (Status LED goes off
after a while).
Note
• For connecting SA11, be sure to use "WU11-M9-02-CN-S"
• For connecting FU20F/FU24F/SC25F, be sure to use "WU11-M9-02-CN-V"
FU20F
or
Sensor + SA11
2.5 Connection with PC/Tablet (Bluetooth pairing)
To access SENCOM sensor/SENCOM Smart Adapter connected to IB100 from the
dedicated software installed in PC/Tablet, it is necessary to do Bluetooth pairing with IB100
and PC/Tablet. For the concrete method of pairing, please confirm how to add Bluetooth
device in Windows. IB100 is displayed as "Yokogawa IB100" in Windows Bluetooth device
menu. Paring only has to be executed once, but if PC pairing is failing remove IB100 and
repeat pairing action. With the dedicated software up to four SENCOM sensors/SENCOM
Smart Adapter can be accessed at the same time by using multiple IB100s, each with their
own COM ports. Please do pairing with each IB100 and PC and note the COM port on the
IB100 device for easy recognition. Be aware that if you replace a IB100 at a COM port, first
remove device before pairing the new IB100.
This figure is the
example case of
connection to SA11
PC/Tablet can find IB100 as Bluetooth device while IB100's status LED is on because it means
Bluetooth communication is available. During paring of IB100 with PC/Tablet the status LED
should be on. When status LED is off you must reseat the connection of the SENCOM sensor/
Smart Adapter. When LED stays off even after reseating then battery needs to be replaced.
[2] Status LED goes on and
Bluetooth communication
become available
IM 12B06J09-01E-E
Female side
MODEL CODE
Serial#
WU11
MODEL CODE
Serial#
Bluetooth pairing
Male side
IB100
PC or Tablet
[1] Reseat the
connection
of SENCOM sensor