Table 9-2 Roller Bearing Greases For Vertical And Horizontal Types Of Construction - Siemens SIMOTICS HV M Operating Instructions Manual

Maintenance
9.1 Inspection and maintenance
Criteria
Additives
FE9 test: A/1500/6000
Behavior in the presence of water
Corrosive effect on copper
Corrosion resistance (EMCOR)
Solid matter content, particle sizes >
25 µm
Suitability of bearings
Speed parameter nxdm
Note
Deviating operating conditions and characteristics
Only use the grease type that is specified on the lubricant plate.
● If the operating conditions differ from those mentioned, other greases may only be used
Note
Use of other greases
If greases other than those named on the lubricant plate are used, it cannot be guaranteed
that they are compatible with the complete system.
● If you use greases that satisfy only the minimum requirements of DIN 51825 or ISO 6743-9,
● If in doubt, consult the manufacturer.
Recommended greases for roller bearings
For standard applications, the following high-quality greases are recommended for roller
bearings for vertical and horizontal motor constructions due to their technical properties:
Table 9-2
Manufacturer
Shell
ExxonMobil
Esso
BP
Fuchs
Lubcon
92
Standard
-
DIN 51821-1/-2
DIN 51807
DIN 51811
DIN 51802 /
ISO 11007
DIN 51813
-
after prior consultation with the manufacturer.
then reduce the lubrication intervals by half or adapt them as appropriate.
Roller bearing greases for vertical and horizontal types of construction
Property, characteristic value
● Anti-Oxidation (AO), Anti-Wear (AW)
● No solid lubricants
● Alternatively: Extreme-pressure (EP) only after
prior consultation with grease and bearing
manufacturers
F10 ≥50 h at +130 °C
F50 ≥100 h at +130 °C
0 or 1 at a test temperature of +90° C
0 or 1 at a test temperature of +120° C
0 - 0
<10 mg/kg
Suitable for the built-in motor bearings, seals and
these speeds
Grease type
Gadus S2 V100 3
Unirex N3
Energrease LS3
Renolit H443 HD88
Turmoplex 3
SIMOTICS HV M 1RN76308PR900CG0-Z
Operating Instructions 07/2018
Unit
-
H
-
Korr.°
Korr.°
mg/kg
-
mm/min