Fault Finding Hints; Environmental Information - Electrolux Flymo Series Instruction Manual

Lubricating the Cutting Blade
For easier operation and longer life, lubricate the
cutter blades before and after use. Apply the oil
so that it runs between the two blades. See Pic L.
At the end of the Cutting Season.
1. Clean your Hedgetrimmer thoroughly.
2. Check that all nuts and bolts are tight.
3. Visually inspect the Hedgetrimmer for any
worn or damaged parts, contact your local
Service Centre if any parts require replace-
ment.
To store your Hedgetrimmer
• The Hedgetrimmer blade cover/storage hold-
er is provided with 2 hanging slots for storing
the Hedgetrimmer on the wall.
(See Pic M)
• Ensure the blade cover is fitted before stor-
age.
• Remove cable from cable holder before stor-
age.
1. The use of 2 number 10 screws (40mm in
length) and the appropriate wall fixing plugs
is recommended
2. Drill 2 holes 48mm horizontally apart.
3. Fit wall plugs.
4. Fit screw ensuring enough length is available
for secure location into hanging slot.
5. Store as illustrated in Pic N.
Fails to Operate
1. Is the Power Turned On?
2. Check the fuse in the plug, if blown replace.
3. Fuse continues to blow?
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
Cutting blade stops under load
1. Cut at a slower pace.
2. If cutting blade still stops under load?
Disconnect from the mains electricity
supply and consult your local approved
Service Centre.
Fails to stop when one switch lever is
released.
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO
14001) using, where practical, components manufactured in the most environmentally responsible
manner, according to company procedures, and with the potential for recycling at the end of the prod-
ucts' life.
• Packaging is recyclable and plastic components have been labelled (where practical) for cate-
gorised recycling.
• Awareness of the environment must be considered when disposing of 'end-of-life' product.
• If necessary, contact your local authority for disposal information.
Caring for your Hedgetrimmer

Fault Finding Hints

Environmental Information

L
M
Store in a dry place where your hedgetrimmer is
protected from damage.
Poor cut quality
1. Ensure the product is being used correctly
(see How to Use)
2. Ensure blades are free from trapped debris
3. Damaged Blades?
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
Excessive Vibration
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
6
N