•
WARNING
Disconnect from the mains electricity
supply, before attempting any
maintenance or adjustment. Cutting head
continues to rotate after the trimmer has
been switched off.
Insert one end of the cutting line into the centre
of the cutting head and push until the end of the
line comes out at one end of the slot. (Fig. H)
Secure the centre piece of the cutting line into
the centre of the cutting head and guide the
other side of the cutting line along the slot until it
is securely located as illustrated in Fig. J.
•
WARNING
Disconnect from the mains electricity
supply, before attempting any
maintenance or adjustment. Cutting head
continues to rotate after the trimmer has
been switched off.
After you have finished using your Flymo
Trimmer follow the procedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water,
cleaning fluids, or solvents, just remove
debris with a suitable tool, a soft brush or dry
cloth.
3. Using the scraper provided, clean around the
inside of the cutting head housing to remove
Poor Trimming.
1. Check length of line. If broken or worn to
less than 20mm from the edge of the cutting
head, replace line. See Removing &
Replacing cutting line.
ENGLISH - 3
Removing broken or worn cutting line
Replacing the Cutting Line
Caring for your Mini-Trim
Fault Finding Hints
For best results, replace the cutting line when
worn to no less than 20 mm from the edge of the
cutting head. (Fig F)
Using the pip in the centre of the line, pull the
line upwards and out of the cutting head. (Fig G)
Storing the spare cutting lines.
Cutting lines can be stored in the storage facility
provided in the back of the trimmer stem. To
store your line, insert one end of the line into the
top slot and one end of the line into the bottom
slot. Then take the centre pip and insert it into
the hole in the middle slot and slide over to the
left as illustrated in Fig. K.
any grass and debris. (Fig L)
4. Using a soft brush, clean around the inside
of the cutting head housing (Fig M), the
cutting head (Fig N) and the motor housing
air vents.(Fig P)
5. Inspect the trimmer carefully, especially the
parts of the cutting head.
6. If your trimmer is damaged in any way
contact your local Electrolux Outdoor
Products approved service centre.
•
Never use a damaged trimmer.
7. Wind cable carefully to avoid kinking.
8. Store in a cool, dry place and out of reach of
children.
2. Check if cutting head is rotating freely.
Remove any debris. See Caring for your
Mini-Trim.