Table of Contents
Advertisement
5
WARNING Avoid accidental starting, keep hands and fingers away from the switch lever whilst attempting
any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS CLATTER-
ING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
U
cap
V
release
latch
cap
release
latch
All manuals and user guides at all-guides.com
Fault Finding Chart
CHECK
Is the automatic line feed working?
Is the line fed out and visible?
Is the manual line feed work-
ing?
Has the motor reached full
speed before use?
Has too much line been fed out?
Is the line cutter missing from
the safety guard?
Are you using the trimmer correctly?
Is the line jamming on the
spool?
Contact Electrolux Outdoor Products Customer Service
Telephone : 01325 300303
Manual line feed
Spool cap and nylon line
W
cap
spoolholder
spool
eyelet
manual line
feed button
Manually feed out line.
No
SEE "MANUAL LINE FEED"
Remove cap and spool, free line
and re-fit spool and cap.
No
SEE "SPOOL CAP AND
NYLON LINE"
The line may be jammed on the
No
spool. Rewind line to remove
crossed loops.
Allow the motor to reach full
No
speed before use
Yes
SEE "MANUAL LINE FEED"
Contact your local approved
Service Centre or Electrolux
Yes
Outdoor Products Customer
Service.
Only use tip of nylon line to trim.
?
SEE "How to trim and edge"
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.
To manually feed the nylon line
If required, line can be fed out manually. To operate, gen-
tly pull on the line whilst at the same time alternately
pressing and releasing the button, on the side of the
spoolholder. See fig U.
Do not depress the button more than three times.
Excessive line will snag the line cutter and cause the
trimmer to malfunction.
To remove spool cap
1. Press and hold in the two cap release latches. See Fig V.
2. Pull cap away from the cutting head. See Fig W.
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Failure to do so may prevent the cap being securely
located in the spoolholder.
2. Align the two latches on the cap with the two windows
in the spoolholder, then press down into the locked
position.
3. Ensure the two cap release latches are clearly visible
and are fully engaged with the windows in the spool-
holder.
4. Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
ACTION
Advertisement
Table of Contents
