5
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS CLATTER-
ING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Q
manual line
feed button
R
cap
cap release
latch
spool
spoolholder
All manuals and user guides at all-guides.com
Fault Finding Chart
CHECK
Is the automatic line feed work-
ing?
Is the line fed out and visible?
Has line been removed from
cleat?
Is the manual line feed working?
Has the motor reached full
speed before use?
Has too much line been fed out?
Is the line cutter missing from
the safety guard?
Are you using the trimmer cor-
rectly?
Is the line jamming on the
spool?
Contact Electrolux Outdoor Products Customer Service
Telephone : 01325 300303
Manual line feed
Cutting Head
1
2
slot
Manually feed out line.
No
SEE "MANUAL LINE FEED"
Remove cap and spool, free line
No
and re-fit spool and cap. SEE
"CUTTING HEAD"
The line may be jammed on the
spool. Rewind line to remove
No
crossed loops. Check that line is
in correct section of spool.
Allow the motor to reach full speed
No
before use
Yes
SEE "MANUAL LINE FEED"
Contact your local approved
Service Centre or Electrolux
Yes
Outdoor Products Customer
Service.
Only use tip of nylon line to trim.
?
SEE "How to trim and edge"
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.
To manually feed the nylon line (Q)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed but-
ton, whilst gently pulling on one of the lines until the
line reaches the line cutter.
3. When the required amount of line is fed out, gently
pull on the second line (there is no need to press the
manual line feed button again).
4. If the line extends past the line cutter, too much line
has been fed out.
5. If too much line is fed out, remove the spool cap and
click spool anti-clockwise until the line is at the
desired length.
To remove spool cap
1. Press and hold in the two cap release latches. (R).
2. Pull cap away from the spoolholder. (R).
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Failure to do so may prevent the cap being securely
located in the spoolholder.
2. Replace the cap, pressing firmly DOWN towards
the spoolholder to ensure cap is fully located.
3. Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
ACTION