Table of Contents
Advertisement
Making Settings for the Input Channels
Making Settings Using an S-4000R
The S-4000R is a dedicated remote controller for digital snake
devices.
Connect the S-4000R to the REMOTE connector on the S-2416 using
the RS-232C cable.
Unlocking
To change various settings on the digital snake device, unlock the
S-4000R.
When the [LOCK] button is illuminated, operation is locked and no
setting operations can be carried out.
Hold down the [LOCK] button for few seconds, and make sure its
light goes dark.
MEMO
To keep settings from being changed by inadvertent operation,
it's a good idea to engage the lock when you have finished
making the input channel settings. Press the [LOCK] button to
engage the lock and make the button light up.
NOTE
When a V-Mixer is connected as a REAC master device, using an
S-4000R or S-4000RCS to control the S-2416 is not possible.
In such cases, make the settings using the V-Mixer.
Adjusting the Preamp Gain
1.
2.
3.
S-4000R
4.
5.
You can adjust the preamp gain on the S-2416 before sending the
signal to a mixer.
Turn the [CHANNEL] knob to select the number of the
channel whose settings you want to change.
Input the audio on the selected channel from the source
devices.
Turn the [GAIN] knob to adjust the gain level.
The indicators around the knob indicate the gain level. The input
level on the select channel is displayed by the input level meter.
Turn the [CHANNEL] knob to select another channel.
Repeat steps 2–4.
MEMO
• If the input level reaches 0 dB, the [CLIP] area of the input level
meter and the [CLIP] area of the signal status indicator light up.
If this happens, the audio may be distorted. To transmit high-
quality audio, adjust the preamp gain so that the peak level on
the input level meter fluctuates between -18 and -3 dB.
• To make the illuminated [CLIP] indicators go dark, press the
[CLIP CLEAR/ENTER] button.
19
Advertisement
Table of Contents
