Smemory-Speed Function, Fixpeed; Sload Monitor Led; Smotor Protection Circuit; Sturn-On-Memory Function - Nakanishi Emax Evoluion Operation Manual

SMemory-Speed Function, FIXPEED

(1) Setting the Memory Speed Function
First with the motor stopped, preset the desired speed on the Speed Control Knob w. Next, press
the FIXPEED Switch !0 for more than 1 second. A 'beep' will sound and the FIXPEED LED!1 will
light. The motor is now set to run at the FIXPEED setting.
To Change FIXPEED Memory
Repeat the above procedure.
NOTE
FIXPEED memory cannot be set over 30,000 min
(2) Using Memory Speed Function
Select the desired motor by pressing either Motor Switch Au or B!2 .
Au = A Motor
After selecting the motor either press the NAKANISHI Smart Switch !9 or press the Motor Switch
again. The FIXPEED LED!1 will flash when the motor is running. During Foot Pedal !7 operation
the FIXPEED set in memory will act as the upper limit and the Foot Pedal !7 will still vary speed.
(3) Clearing the FIXPEED Memory
Push and hold the FIXPEED Switch !0 , a 'beep' will sound and the FIXPEED LED!1 will shut off.
The FIXPEED memory is cleared.
(4) To Undo the Clear
Press the FIXPEED Switch !0 , the FIXPEED LED!1 will light. The FIXPEED memory has been
restored.
* When the Emax Evolution system is shipped from the factory, the FIXPEED is preset for both
motor A and B to 20,000 min

SLoad Monitor LED

The motor handpiece /control unit load is displayed by 6LED's (3 Green,2 Yellow,1 Orange).
Continuous operation is possible with up to all 3 green LED's lit.

SMotor Protection Circuit

When the motor is operated with a load exceeding its limits or the handpiece is locked, the Motor
Protection Circuit operates and interrupts the power supply to the motor. When the Motor Protection
Circuit has been triggered an Error Code appears on the Speed Display e.
Resetting the Motor Protection Circuit
During manual operation the circuit can be reset by pressing Motor Switch A u or B !2 again. During foot
pedal operation, release the Foot Pedal !7 completely and the circuit will be reset.

STurn-On-Memory Function

When the Power Switch !5 is turned On, the rotation direction and FIXPEED selections being used
when the unit was shut down are restored. Please pay careful attention to the rotation direction.
B!2 = B Motor
.
-1
-1 .
6