Soperating Procedures - Nakanishi Emax Evoluion Operation Manual

SOperating Procedures

(1) Insert the Power Cord Plug @2 in a grounded wall
outlet.
(2) Make sure the Speed Control Knob w is set at the
lowest speed position.
(3) Turn Power Switch !5 ON , and check if Speed
display e shows.
(4) Select the direction of rotation with the
Forward/Reverse Selector Switch t. Each time this
switch is pressed, the direction changes. When the
FWD./REV. LED y is not lit, it shows Right hand
rotation (FWD.)
(5) To switch between motor A and motor B press either Au or B!2 to select the respective motor.
The LED on the control unit for the selected motor will light. Either push Au or B!2 again to start
rotation or push the NAKANISHl Smart Switch on the appropriate motor.
CAUTIONS
• If the motor LED is already lit pressing the Au or B!2 button will start rotation. Please
look carefully at the control unit's front panel before pushing the motor select button.
• Motor A and B can not be run simultaneously.
Operation 1
Manual Operation
(6) Set the rotation speed with the Speed Control Knob w and check the speed on the Speed Display e.
(7) Select the desired motor by pressing either Motor Switch Au or B!2 .
Au = A Motor
After selecting the motor either press the NAKANISHI Smart Switch !9 or press the Motor Switch again.
(8) To stop the motor rotation either press Motor Switch Au or B!2 or the NAKANISHI Smart Switch again.
Operation 2
Foot Pedal Operation
(6) Set the maximum rotation speed with the Speed Control Knob w and check the speed on the Speed
Display e.
(7) Depress Foot Pedal !7 and the motor will rotate. The rotation speed can be varied up to the preset
maximum, depending on the degree of depression of the Foot Pedal !7 .
* Auto Speed System
To fix the speed within the range set by the Speed Control Knob w, with the motor running,
depress the Foot Pedal !7 to the desired speed and press Motor Switch Au or B!2 , depending
on which motor is being used. The Motor LED on the control unit will flash and the rotation speed
will be maintained even if the Foot Pedal !7 is released. To cancel the Auto Speed System press
Motor Switch Au or B!2 , the NAKANISHI Smart Switch !9 or depress the Foot Pedal !7 again.
5
B!2 = B Motor
2
3
4
5
6
7
8
9
15
1
10
11
12
13
14
Fig. 6