Soptional Motors And Handpieces - Nakanishi Emax Evoluion Operation Manual

Attachment
Trouble
The Attachment does not turn
with the chuck closed
Attachment gets hot during
use
Vibration or Noise during use
High Runout
Bur slips out

SOptional Motors and Handpieces

Product
97
108
64
60
61.4
102
120
62.3
96
57.3
ø12.8
119
85.4
185
41.9
50.1
Cause/Check
Bearings Contaminated or Seized.
Bearings Contaminated.
Same as Above.
Bur is bent or damaged.
Contaminants in chuck or spindle.
Chuck is worn.
Bearings worn.
Chuck is Loose.
Model No.
Model No.
Standard Type Motor
ENK-410S
Torque Type Motor
ENK-250T
Ring Type Attachment
IR-310
Lever Type Attachment
IH-300
Straight Type Attachment
IG-400
Torque Type Attachment
HG-200
BMH-300
MFC-300S
MFC-300M
90˚Angle Attachment IC-300
45˚Angle Attachment KC-300
Reciprocating Type Compact
Grinder LUSTER LS-100
Reciprocating Type Compact Grinder
(Built in motor) LUSTER NLS-110
MINI-LUSTER
ML-8
Fine Belt Sander
KBS-101
1/4 Reduction Gear
RG-01
Extension Joint
CN-01
Send for Service.
Same as Above.
Same as Above.
Replace the bur.
Clean the chuck and spindle ID.
Replace the chuck.
Send for Service.
Adjust the Chuck.
Specification
1,000-40,000min -1 Brushless Motor. Excellent combination of high
speed, light weight, small diameter, high torque and FWD/REV
rotation.
1,000-25,000min -1 Brushless Motor. Higher power and higher
torque than Standard motor ENK-410S.
Ring type chucking system makes it easier to change tools.
Simple lever turning for bur exchange. Designed to make it light
weight and fit to pen-grip type holding. ø2.35mm, ø3.0mm or
ø3.175mm (1/8")
High precision NK Micron Collet Chuck system. Strong tool
retention strength and highly precision metal removal are
achieved.
Chuck Diameter ø6.0mm or ø6.35mm (1/4")
This unique slim body makes it ideal for cutting and grinding the
bottom surface of deep ribs or holes Chuck diameter ø3.0mm
or ø3.175mm (1/8") Optional ø2.35mm
90˚MINI ANGLE TYPE Attachment for Chamfering Deep Hole,
Bur Only ø1.6mm
90˚Angle attachment with ø3.0mm or ø3.175mm (1/8") Collet Chuck.
When using it with Rubber Pad or Felt buff in lower speed, please use
RG-01 Reducer together.
The grinding surface can be set at any between 0 and 360˚.
Stroke range:0-6mm adjustable by allen wrench.
Stroke range of 0.8mm, Reciprocating Stroke (variable):Approx0-9,000 times/min.
Suitable for polishing narrow grooves, details, etc. Stroke range of 0.8mm.
8mm Belt (Grits #120, #240, #400 )
6mm Belt (Grits #120, #240, #400 )
4mm Belt (Grits #120, #240, #400 )
May be Connected between Motor and Attachment for 4 time
the Regular Power
Joint used by Connection between Attachment and Motor to
Extend the Length
Remedy
14