ESAB Origo Feed 304N P4 Manual page 25

6.3) Installation of the feeder
1) Connect the wire feeder to the power source through the cable of comand.
2) Fix the welding cable connected to the terminal + power source in the terminal in the wire feeder.
3) Fix the hose of the gas pressure regulator in the inlet niple of the rear solenoid valvule of the wire feeder.
4) Install the welding gun (see especific manual).
5) Install the wire.
6) Install the feed rollers according to the type and wire diameter to be used.
Table 6.1
TABELA 5.1
Wire type
Pressure roller
Steel
Aluminiun
Cored
Table 6.2
Wire diameter (mm)
Input noozle
Intermediate noozle
Output noozle
Diameter (mm)
0,60 - 0,80
0,80 - 1,00
1,00 - 1,20
1,20 - 1,60
1,00 - 1,20
1,20 - 1,60
2,40 - 3,20
1,20 - 1,60
1,60 - 2,40
2,80 - 3,20
0,60 - 1,60 1,60 - 3,20
0900988 0901094
0900368 0900896
0900261 0900618
- 25 -
0900467
0900905
0900251
0901338
0900822
0900168
0901272
0900732
0900121
0901204
0902230