Operation
Turn the tool on with the air-
flow switch. Preset the
temperature you require
Changing the heating element
The plug-in heating element
in the Weldliner
can be changed
in a matter of seconds.
Changing the power cord
If the power cord is damaged,
it can easily be changed
without opening the casing.
c
10
(50 – 600 °C) with the tem-
perature switch. The air-
flow rate may be continu-
b
a
ously varied with the airflow
switch
.
1. Important: Disconnect
tool from power supply.
2. Undo the 4 screws at the
end of the guard sleeve.
3. Pull off guard sleeve with
outlet tube and heating
element and exchange for
new element.
4. Firmly screw guard sleeve
back on.
5. Attention: Knock guard
must remain properly
engaged.
1. Important: Disconnect
tool from power supply.
2. Undo screw and pull off
cover cap
3. Release cable grip
4. Undo mains terminals
5. Pull out cord
6. Insert new cord and
secure in reverse order
d
(1. Firmly screw down
mains terminals etc.).
a
.
b
.
c
.
d
.