Mira Select Installation And User Manual page 25

3.6 Drill the two 5.5 mm holes for the
fi xing positions (countersink the holes
at the front).
3.7 Secure the unit with the M5 x 40 mm
screws as shown.
3.8 Fit the hot and cold supply pipes
(hot - left, cold - right) and tighten
the compression nuts.
Caution! Make sure that the olives
are fi tted and all pipework is fl ushed
through before connecting to the
unit.
3.9 Connect the outlet pipework, leaving
enough pipe to connect a 1/2" BSP
female fitting (not supplied) to
the Right Angle Connector (RAC)
assembly.
3.10 When the 1/2" BSP female fitting
and brass nipple have been fi tted to
the outlet pipework, temporarily seal
off the open end with an appropriate
fi tting (not supplied) and turn on the
water supplies to check for leaks.
3.11 Fit the Shower Fittings. Refer to the
"Shower Fittings Installation and
User Guide" for further details.
Note! For high pressure systems, a
12 litre/minute white Flow Regulator
(supplied) can be fi tted under the
Hose Washer.
3.12 Fit the Concealing Plate and Control
Assembly. Refer to section: "Control
Assembly" for further details.
Outlet Pipe
to Fittings
Backnut
(not supplied)
25
M5 x 40 mm
Fixing Screws
Cold Supply
Hot Supply
Finished Wall
Surface
20 to 22 mm