Mira Select Installation And User Manual page 20

1.12 Connect the outlet pipework, leaving
enough pipe to connect a 1/2" BSP
female fitting (not supplied) to
the Right Angle Connector (RAC)
assembly.
1.13 When the 1/2" BSP female fitting
and brass nipple have been fi tted to
the outlet pipework, temporarily seal
off the open end with an appropriate
fi tting (not supplied) and turn on the
water supplies to check for leaks.
1.14 Attach the Building-in Shroud to the
unit using the two Shroud Screws
removed earlier.
1.15 Using the Building-in Shroud as a
guide, fi nish the wall, e.g. tiles.
Caution! Make sure that the fi nished
wall is within the maximum and
minimum limits and to an even depth
(no greater than 2 mm variation) or
the control components will not fi t
correctly.
1.16 Remove the two Shroud Screws
(retain for later use) and remove the
Building-in Shroud.
1.17 Fit the Concealing Plate and Control
Assembly. Refer to section: "Control
Assembly" for further details.
Backnut
(not supplied)
20 to 22 mm
Solid or
Dry-lined
wall
Minimum Finished
Wall Surface
Maximum Finished
Wall Surface
20
Finished Wall
Surface
20 to 22 mm
Laminated Panel
or Stud Partition
wall
F9802
Finished Wall
Min
Max