Thrust Bearing - Chevrolet Chevelle 1967 Overhaul Manual

CLUTCH AND TRANSMISSIONS 7-95
SPEEDOMETER
DRIVE GEAR
SNAP
RING
FLANGED
THRUST
WASHER
REAR
INTERNAL
GEAR
I.D. FLANGE O.D. FLANGE
RACE RACE
BEARING
" O " RING
O.D. FLANGE
RACE
I.D. FLANGE
RACE
MAIN SHAFT
THRUST WASHER
FRONT INTERNAL
REACTION GEAR RING
CARRIER
ASSEMBLY
Fig. 114T-Gear Unit Assembly - Exploded View
c. Install second race, center flange up (fig. 12IT).
16. Install rollers that may have come out of the roller
clutch cage, by compressing the energizing spring
with forefinger and inserting roller from the outer
edge. (fig. 122T)
17. Install roller clutch assembly (fig. 123T) into re-
action carrier.
18. Install center support to reaction carrier phenolic
thrust washer into recess in center support. Retain
with petrolatum (fig. 4IT).
19. Install case center support into roller clutch in
reaction carrier (fig. 124T).
NOTE: With reaction carrier held, case center
support should only turn counter-clockwise after
installation.
20. Install J-21795 on gear unit assembly to hold units in
place.
SNAP RING
O.D. FLANGED RACE
I.D. FLANGED RACE
THRUST BEARING
Fig. 115T—Installing Rear Internal Gear to
Main Shaft Snap Ring
Fig. 116T—Installing Rear Internal Gear to
Sun Gear Bearing and Races
CHEVROLET CHASSIS OVERHAUL MANUAL