Chevrolet Chevelle 1967 Overhaul Manual page 182

CLUTCH AND TRANSMISSIONS 7-24
Fig. 22c—Checking Countergear End Play
6. Install the mainshaft assembly from the rear of the
case picking up the spacer, pilot bearings and third
speed blocker ring (fig. 23C).
CAUTION: Be sure the clutch gear engages the
teeth of the countergear anti-lash plate.
7. Install reverse idler gear shaft and woodruff key.
CAUTION: Be sure that idler gear shaft picks
up both thrust washers during installation.
8. Install extension gasket to rear of case and using
snap ring pliers expand the extension to bearing snap
ring and install extension over mainshaft and rear
bearing. Be sure snap ring has started over the
ALIGN BLOCKER
RING NOTCHES
WITH CLUTCH KEYS
9.
10.
Fig. 24c—Installing Clutch Gear Bearing Using J-5590
rear bearing, then install and tighten extension to
case bolts to specified torque (fig. 5C). Use graphite
sealer on the two lower attaching bolts.
CAUTION: Care should be taken not to damage
the extension bearing or oil seal during
installation.
Tap on front of clutch gear shaft to force rear
bearing to extension snap ring to seat in its groove.
Using Tool J- 5590 drive the clutch gear bearing onto
the clutch shaft and into the case (fig. 24C). Install
washer and snap ring to input shaft (fig. 6C).
Fig. 23c—Installing Mainshaft Assembly to Case
Fig. 25c—Installing Side Cover and Shift Forks
CHEVROLET CHASSIS OVERHAUL MANUAL