Chevrolet Chevelle 1967 Overhaul Manual page 224

CLUTCH AND TRANSMISSIONS 7-66
Fig. 8T—Removing Strainer Assembly and " O " Ring
Fig. 61—Removing Speedometer Driven Gear Retainer
b.
Install a 3/8"-16 threaded slide hammer bolt or
J-9539, into bolt hole.
Mount a dial indicator on rod and index indicator
to register with end of turbine shaft.
Push on turbine shaft rearward.
Push output shaft forward.
Set dial indicator to Zero.
Pull turbine shaft forward.
Read resulting travel or end play. Should be 003"-
.024".
Selective washer controlling this end play is the
phenolic resin washer located between pump cover and
forward clutch housing. If more or less washer thickness
is required to bring end play within specifications, select
proper washer from the following chart:
c.
d.
e.
f.
• g .
Thickness
.060 - .064
.071 - .075
.082 - .086
.093 - .097
.104 - .108
.115 - .119
.126 - .130
Color
Yellow
Blue
Red
Brown
Green
Black
Purple
NOTE: An oil soaked washer may tend to dis-
color, so it will be necessary to measure washer
for its actual thickness.
DETENT ROLLER AND
SPRING ASSEMBLY
Fig. 7T—Removing Transmission Oil Pan Attaching Screws
Fig. 9T-Removing Detent Roller and Spring Assembly
CHEVROLET CHASSIS OVERHAUL MANUAL