MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
BELT REPLACEMENT
Inspect the belt afler every 100 hours of service. Belts that show visible signs of wear such as cracks or fraying at the
edges should be replaced immediately.
1.
Turn off and unplug the machine from the power-
source and remove the lock-out key.
D
3.
Pull back the lock lever D and then raise and pull
back again to remove it E.
5.
Handle both covers and lift them to detach them
and then to remove them as shown.
E
A
B
2.
Unlock the cutter head and raise the cutter head
to the maximum point A. Remove the handwheel
screw with a 4 mm Allen key B, and pull back the
handwheel to remove it C.
4.
Remove the screws located in the top of the right
cover F.
6.
Remove the right side cover.
C
E
21