Table of Contents
Advertisement
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
A
5.
Remove the screw A with a 4 mm Allen key.
B
7.
Insert a 4 mm allen key B into the cutter head hole
of the planer as shown to keep the cutter head
from turning while changing inserts.
E
9.
Thoroughly clean the inserts E and screws F using a
lacquer thinner and small brush then apply a light
coating of machine oil on the screws, taking care
to remove any excess.
Note: When rotating the inserts in the cutter head, refer
to the etched mark G on the inserts to keep track of the
rotations.
20
G
6.
Slide finger into the opening and pull back the
cover to detach it as shown.
C
8.
Immobilize the cutter head using a the 4 mm Al-
len key C, and remove the 26 inserts using the sup-
plied Torx™ key D. Thoroughly clean the housing
and cavity before turning/replacing an insert.
F
10. Place each insert in the housing and firmly secure it
in place with a screw.
Note: To avoid stripped screws and cracked inserts, do not
overtighten the screws.
D
Advertisement
Table of Contents
