MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
ALIGNING INFEED AND OUTFEED TABLES
1.
Place a straightedge across the infeed table and
the main table and verify that the two tables are
aligned. If the tables are not aligned, go to the next
step.
LEFT SIDE
B
3.
Turn bolts B in the required direction until the infeed
table is aligned with the main table.
ADJUSTING THE DEPTH OF CUT SCALE
1.
Plane a board and measure its thickness to veri-
fy that is the same as the value indicated by the
depth of cut scale.
14
RIGHT SIDE
B
C
LEFT SIDE
A
2.
Loosen jam nuts A located in the front corners of
the infeed table.
4.
Retighten jam nuts A, then repeat steps 1 to 4 for
the oufeed table.
D
2.
Loosen screw D with a flat head screwdriver, then
set the pointer on the scale so that it indicates the
correct thickness. Retighten screws D once the ad-
justment is completed.
RIGHT SIDE
A