Table of Contents
Advertisement
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE "OFF" POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
3.
Insert the handwheel knob into its mounting hole
as shown.
INSTALLING THE LOCK-OUT KEY
1.
Insert the safety key into the switch as shown.
INSTALLING THE DUST CHUTE
B
1.
Slide the dust chute under the two lock knobs B as
shown.
10
4.
Insert the cap screw A into the same mounting hole
from the other side of the handwheel and tighten
the screw with the supplied Allen key.
Note: Make sure the switch is in the OFF position.
B
2.
Align the center mounting hole C with the corre-
sponding hole in the machine and then tighten the
lock knob D. Tighten the two lock knobs B.
C
D
Advertisement
Table of Contents
