Table of Contents
Advertisement
MAINTENANCE
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
PERIODIC MAINTENANCE
•
Inspect/test the ON/OFF switch before each use. Do not operate the planer with a damaged switch; replace a
damaged switch immediately.
•
Keep the machine as well as the in-feed and out-feed tables clean and free of saw dust, woodchips, pitch or glue.
Vacuum or brush off any loose debris and wipe down the machine and the tables occasionally with a damp
rag.
•
An occasional light coating of paste wax can help protect the tables' surface and reduce workpiece friction.
Ask your local distributor for suggestions on aftermarket surface cleaners, protectant and dry lubricants based
on what is readily available in your area.
•
Avoid using silicon based products that may affect wood finishing products such as oil, solvent or water-based
stains, varnishes and lacquers.
•
Periodically inspect the power cord and plug for damage. To minimize the risk of electric shock or fire, never
operate the planer with a damaged power cord or plug. Replace a damaged power cord or plug at the first
visible signs of damage.
•
The motor and cutter head bearings are sealed and permanently lubricated – no further lubrication is
required.
•
The drive gears, chain and elevation screws should be cleaned of woodchips, dust, debris and old grease after
every 10-15 hours of use. After cleaning, re-apply a generous coating of any common automotive bearing
grease.
•
Regularly inspect planed workpieces for signs of knife damage or wear and replace damaged or worn knives
immediately.
INSPECTING CUTTER HEAD INSERTS
A
There are 26 carbide inserts installed in the cutter head A at the factory. With usage and normal wear over time, it
will eventually become necessary to rotate and/or replace the inserts. To maintain even insert wear always reverse
or replace all 26 inserts each time knife replacement is required. When needed, replacement inserts B can be
ordered through your local General International distributor under part #30-006.
18
B
*EACH INSERT HAS TWO CUTTING EDGES C. WHEN ONE EDGE
BECOMES DULL OR DAMAGED, SIMPLY ROTATE THE INSERT TO
USE THE OTHER EDGE.
C
Advertisement
Table of Contents
