Walky-Talky Mode - Siemens Gigiaset SL37H Manual

Table of Contents

Advertisement

Deactivating the room monitor
remotely
Preconditions: The phone must support
touch tone dialling and the room monitor
should be set for an external destination
number.
¤
Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There will be no further
room monitor calls. The other room monitor
settings (e.g. no ringer tone) on the handset
will remain activated until you press the dis-
§OFF§
play key
on the handset.
To reactivate the room function with the
same phone number:
¤
Turn on the activation again and save
§Save§
with
.

Walky-talky mode

Walky-talky mode allows two handsets to
communicate with each other, both inside
and outside the range of the base station to
which the handsets are registered.
Handsets that are to communicate with each
other using walky-talky mode must meet
one of the following conditions:
u
The handsets are all registered to the
same base station.
u
The handsets are set to Best Base or are
not yet registered.
In walky-talky mode, if you press the talk key
c
or the handsfree key
go to all handsets that are in walky-talky
mode. The connection is made with the first
handset to accept the walky-talky call.
Please note:
u
The maximum range outdoors is 300 m.
u
Handsets that are in walky-talky mode
are not available for phone calls.
u
The handset operating times are greatly
curtailed.
18
d
, the call will
Activating/deactivating
walky-talky mode
¢
¢
v
í
Walky-Talky
§OK§
Use
to activate walky-talky mode. You
can now:
§OFF§
Press the display key. Walky-
talky mode is switched off.
or
¨
Press the display key to open
the menu.
The following functions can be selected with
q:
Audio Settings
You can set Ringer Settings (
and Advisory Tones(
talky mode.
Room Monitor
You can use the handset in walky-talky
mode as a room monitor.
Using a handset in walky-talky
mode as a room monitor
¢
¨
Room Monitor
¤
Change multiple line input:
Room M.:
Select On to activate.
Level:
Set noise level sensitivity (Low or High).
¤
Save the changes.
The room monitor will use all the handsets
that are in walky-talky mode.
Switch the room monitor off by pressing the
§OFF§
display key
on the handset that was
used to activate the room monitor. The
handset reverts to normal walky-talky mode.
¢
S. 21)
¢
S. 23) for walky-

Advertisement

Table of Contents
loading

Table of Contents