Changing The Battery - Schaudt Electrobloc EBL 99 K Series Instruction Manual

Instruction Manual for Electrobloc EBL 99 K / EBL 99 K with OVP

Changing the battery

4
Outputs are exceptions:
Floor light/step
F
Heater
F
Frost protection valve
F
These outputs are not disabled via the main switch of the IT ... /LT control
and display panel.
Please refer to the operating instructions of the IT ... /LT... control and
switch panel for further information. .
3.2 Changing the battery
ATTENTION!
Y
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electrobloc:
Batteries should only be changed by qualified personnel.
F
Follow the battery manufacturer's instructions.
F
Only connect the electrobloc to 12V power supplies with rechargeable
F
6-cell lead gel or lead acid batteries. Do not use any unsuitable bat-
tery types.
Normally only batteries of the same type and capacity should be used,
Y
i.e. same as those installed by the manufacturer.
It is possible to swap lead acid batteries with lead gel batteries. However,
Y
swapping from lead-gel-batteries to lead-acid-batteries is only possible in
certain cases. Contact the vehicle manufacturer for more information.
Electrically isolate the battery from the electrobloc by disabling the bat-
tery cut-off switch on the electrobloc (also see Section 3.4).
Replace battery.
After changing the battery, recheck which type of battery has been inser-
ted.
DANGER!
Y
Incorrect setting of the battery selector switch.
Risk of explosion due to build up of explosive gases:
Set the battery selector switch to the correct position.
F
Disconnect the electrobloc from the mains before adjusting the battery
selector switch.
Fig. 1 Battery selector switch
F
F
Date: 20.01.2010
AES/compressor refrigerator
Spare 4
1
811.419 BA / EN