Sewing On Buttons (For Sew&Go 5) - Bernette Sew&Go 1 Instruction Manual

sew&go 5
Stitch width dial
1
2
Stitch length dial
3
Sewing on buttons
1. Install the darning plate.
Change presser foot to button-sew-on foot.
Position the work under the foot.
Place the button on the marked position and
lower the foot.
- Set the stitch selector dial on "
a few securing stitches.
- Set the stitch selector dial on zig-zag stitch
" " and adjust the stitch width to 3 - 5
according to the distance between the two
holes of the button. Turn the handwheel to
check if the needle goes into the right and
left hole of the button without any
obstruction. Slowly sew on the button with
about 10 stitches.
- Select stitch " " and finish the sewing on
button with sewing a few securing stitches.
2. If a shank is required, place a darning needle
on top of the button and sew.
3. For buttons with 4 holes, sew through the
front two holes first, push work forward and
then sew through the back two holes as
described.
" and sew