ASK76.1U Conduit Adapter
Product Description
This kit provides an adapter that allows for a conduit
connection to the OpenAir™ GDE/GLB models.
Contents
This kit contains one conduit adapter and a flat head
screw.
Product Numbers
ASK76.1U
Required Tools
•
Flat head screw driver
•
4 mm hex wrench
Expected Installation Time
10 minutes
Installation Conventions
WARNING
CAUTION
Prerequisites
Provide a conduit connector.
Installation
Loosen and remove the stop set screw and nut from the
actuator. See Figure 1
Item Number 129-262, Rev. BA
Personal injury/loss of life may
occur if you do not follow a
procedure as specified.
Equipment damage or loss of
data may occur if you do not
follow a procedure as specified.
Figure 1.
Attach the desired conduit connector to the base of the
conduit adapter.
NOTE: A second opening in the base of the
adapter is available by removing the
knock-out.
Figure 2.
Thread the cable through the opening(s) in the conduit
adapter.
Set the actuator in the adapter so that the actuator
fits into the guide on the adapter.
Installation Instructions
Document No. 129-262
September 30, 2009
Page 1 of 2