General Information; Manufacturer's Details; Dryer Specifi Cations - Parker Zander WVM 40 Operating Manual

EN | Operating manual

General information

Manufacturer's details

Parker Hannifi n Manufacturing S.r.l.
Sede Legale: Via Privata Archimede, 1- 2009 Corsico (MI) Italy
Sede Operativa: Gas Separation and Filtration Division EMEA - Strada Zona Industriale, 4
35020 S.Angelo di Piove (PD) Italy
tel +39 049 971 2111- fax +39 049 9701911
Web-site: www. parker.com/hzd
e-mail: technical.support.hiross@parker.com
Dryer Specifi cations
Scope of delivery
Adsorption dryer, consisting of:
◊ 2 vessels fi lled with desiccant
◊ 1 Heater
◊ 1 Vacuum pump
◊ 1 Switch cabinet including control system
◊ 1 Key for switch cabinet
◊ Piping and silencer
Supplementary documents (standard scope)
◊ Operating manual (i.e. this document)
◊ Operating manual of pertaining controller
◊ Operating manual of fi tted vacuum pump
◊ Technical documents (see appendix):
— Dimensional drawing
— Process diagram
— Pneumatic diagram of the control air unit
◊ Electrical diagramsi
Notes on supplementary documents
Supplementary documents such as operating manuals for options or pertaining components
must always be heeded. They contain additional information, e.g. regarding maintenance,
and are therefore necessary for safe operation of the plant.
Notes on upstream and downstream fi lters
Upstream and downstream fi lters are not contained in the standard scope of delivery of the
dryer. For this reason, the operator must install at least an upstream fi lter. Please also heed
the notes regarding the intended use on page(10)
Warranty notes
In the following cases, the warranty shall be void:
◊ If aggressive media in the compressed air and in the environment cause corrosion damage
and functional faults on the dryer.
◊ If the dryer is used without prior approval and confi rmation in writing by the manufactur-
er for purposes other than those specifi ed in these operating instructions or contractually
agreed.
◊ If preset parameters (e. g. on the control system etc.) are changed without prior approval
and confi rmation in writing by the manufacturer.
◊ If the dryer is transported or stored incorrectly.
◊ If the dryer is sited and installed incorrectly.
6
General information
WVM 40 -1450