chine must be performed in accordance with the information and Index Always disconnect the appliance from the main power sup- Always disconnect the dryer from the main power sup- instructions given in the technical documentation supplied and ply before starting maintenance work. always in such a way to avoid the creation of a hazardous situa- Safety tion.
Page 4
English SPL002 ---030 (60Hz) Install a differential thermal magnetic circuit breaker with c) in the event of unforeseen excess air flows, by--- pass to avoid Inspection overloading the dryer; contact opening distance ² 0.12 inches (3 mm) ahead of the sys- a) All units are assembled, wired, filled with coolant and oil, and tem (IDn = 0.3A) (see the relevant current local regulations).
The following are available (see par. 8.4): Maintenance Preventive Maintenance Programme a) compressor kits; To guarantee lasting maximum dryer efficiency and reliability: a) The machine is designed and built to guarantee continuous b) fan kits; operation; however, the life of its components depends on the c) automatic expansion valve kits;...
English SPL002 ---030 (60Hz) Troubleshooting FAULT CAUSE REMEDY Overload High refriger- Excessive Cooling air outlet High pressure Compressor protector ant discharge too high / High current drop on air noisy (SK/HT) tripped pressure dew point consumption side Fan pressure Ambient Heat exchanger Ice formation switch (PV)
Page 7
8 Appendix 8.1 Legend Meaning Meaning ① ⑫ Compressor Fan pressure switch ② ⑬ Refrigerant condenser High temperature safety thermostat ③ ⑭ Fan motor Main power switch ④ ⑮ Evaporator Cover ⑤ Separator Electronic condensate drain power supply ⑥ Power cable Overload protector ⑦...
8.2 Installation diagram Air compressor Dryer By---pass unit Safety valves for not exceeding dryer design pressure Filter (3 micron filtration or better) near dryer air inlet Tank in position A or in B Hoses for air connections if the system undergoes vibrations Outlet filter Suitable dampers if the system undergoes pulsations Oil---Water separator...
Page 19
2012 Parker Hannifin Corporation. Product names are trademarks c 2012 Parker Hannifin Corporation. Product names are c 2012 Parker Hannifin Corporation. Product names are c 2012 Parker Hannifin Corporation. Product names are Parker Hannifin Corporation or registered trademarks of their respective companies...
Need help?
Do you have a question about the PRD10 and is the answer not in the manual?
Questions and answers